













Tiny Ape Freestyle is the first 2.5'' drone for Darwinfpv. In order to meet the needs of more friends and we have made multiple attempts. It comes with the Darwin ELRS2.0 F411 15A Bluejay AIO and the VTX006 which has 25-600mW output power.
Drone Configuration:
Weight: 50.3g (without batteries and paddles)
Propeller: Genfan 2512 3-blade propeller
FC&ESC:F411 2S 15A FC(Built-in ELRS 2.4G receiver)
Built-in Receiver Protocol: SPI protocol
Motor: 1103 8000KV Brushless Motor
Camera: Run Cam Nano 4
VTX:25-600mW VTX
AIO Firmware: betaflight_4.3.0_BETAFPVF4SX1280
ESC Firmware: Bluejay_S_H_50_48_v0.14
Recommended Battery: 2S 380-450mah
Factory AIO firmware just only support ELRS_V1.0 if you want to use it with the ELRS V2.0 versionTX Module and you can programming Betaflight V4.3.0 RC1-RC3. The name of the firmware is BETAFPVF4SX1280. After flashing the ELRS_V2.0 flight controller firmware, you need to flash the CLI and VTX configuration files. The following are the built-in receiver pairing tutorials and CLI files that need to be flashed after the update:
Darwin AIO 002 FC Pairing Tutorial
Run Cam Nano 4 Camera
The Run Cam Nano 4 uses a 1/3'' CMOS sensor, 2.1mm lens and 800TVL resolution for truer colors and clearer low-light night vision.
1103 8000KV Brushless motor
1103 8000KV Brushless motor is only 3.7g and it's power and thrust are surprising, and the flight time is achieved? Minutes. We have notice: the motor only supports 2S batteries, and if it is connected to 3S to push the oil too much the motor will be permanently damaged .
380mah(3S) |
450mah(2S) |
|
Landing voltage |
9.75V |
6.5V |
VTX Power |
400mW |
400mW |
Hover Time |
8.25min |
8.18min |
VTX
VTX006 has 25-600mW output power and can provide stable images and powerful transmission. You can choose the perfect output power according to you FPV requirements. ( The default setting of the output power for Tiny Ape is 400mW)
Red light flashes frequency |
Power |
1 |
25mW |
2 |
200mW |
3 |
400mW |
4 |
600mW |
Flight Control(FC)
This is an updated version of Darwin AIO. We integrated the ELRS receiver on the FC to make it easier to apply to mini drones. The ESC adopts Bluejay firmware, compatible with 1-3S Lipo input, 15A continuous current and 17A peak current. FC provides 2 sets of Uarts interfaces, and also provides various external device interfaces such as SBUS, Softserial, CTR, BUZZ, RGB, etc., which perfectly solves the problem of insufficient number of F411 Uarts.
The built-in receiver is an SPI protocol receiver, so you need to select SPI receiver support (SPI RX support) in the betaflight configurator. Under normal circumstances, the checkbox on the betaflight configurator receiver is empty. If the betaflight configurator used is 10.8.0 and above, the checkbox should select "EXPRESSLRS". As shown below:
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.